Condition: Used-Very Good

Price: 49,500.00

Detailed Description:
GNUTTI MODEL FMF-9-125 AUTOMATIC ROTOCYCLE ROTARY BORING, REAMING TAPPING AND THREADING MACHINE

This machine was purchased by the selling compnay in 1997 and the machine at that time was then as it is now in very good condition. The total investment for the machine in 1997 was $265,000.00. Selling company is now looking for offers.

Serial No. 4212 New -1974

Motor Driven with (2) 5/3-3 H.P., 2 Speed, 3 Phase, 60 Cycle 440 Volt Spindle
Drives. (5) 5/3 HP. 2-Speed, 3 Phase, 60 Cycle 440 Volt Spindle Drives. M.D.
Chip Conveyor. M.D. Coolant System. Complete with Free Standing Electrical
Control Cabinet with Individual Controls for the following:
Left Front Spindle (Left Reamer)
Upper Center (Not Used/Empty Station)
Right Front Spindle (Right Reamer)
Left Rear Spindle (Left Spot Facer)
Left Middle Spindle (Left Thru Drill)
Top Spindle (Ballseat Drill)
Lower Center (Not Used/Empty Station)
Right Rear Spindle (Right Spot Facer)
Right Middle Spindle (Right Thru Drill)

EQUIPPED WITH, Oil Pneumatic Driven 8-Station Turret Transfer System for Work with Rack and Pinion Drive and Positive Lock/Locator Systems. The Machine is Designed to Accommodate a Total of Nine Working Spindles. There are Presently Seven Working Spindles on the Machine as Described Above. Machine Mounted Operator Control Station for Automatic Cycle. Semi-Automatic Cycle. Manual Cycle. Power On. Speed. Turret Indexing. Locked Turret, Units Feed In. Units Feed Out. Stop and Feed Out. Chucks Opening. Brake Release. Chip Conveyor. Coolant Pump. Machine Mounted Dual Palm Buttons for Cycle Stan. Machine Mounted E-Stop, Jorgensen 12" Wide Motor Driven Slat Type Chip Conveyor. M.D. Coolant System. Work Light. Manuals and Drawings.

Spindle Stroke 5"
Rapid Feed Rate (In/Out) 300 IPM
Working Feed Rate 0 - 80 IPM
Spindle Nose IS040


DATE: AUGUST 28,1997
RE: BREAKDOWN OF GNUTTI SHAPE MACHINE

$ 90,000 Gnutti Machine at In its current condition it is only capable of drilling. (See above quote).

$105,000 (3) tapping heads in order to make shapes and do threads. This cost was based on verbal estimate from Gnutti.
$ 55,000 Bar Cutter and Loader for machine. This portion is the part that cuts the
bar stock and loads it into the machine. Based on estimate

$250,000 TOTAL MACHINERY & EQUIPMENT

$ 15,000 Die Heads/Drill Holders for NTA shapes- Based on estimates from

$265,000 TOTAL With TOOLING