Sold!
Buy one like this

I want to sell a machine like this

  • Automatic
  • Warner & Swasey
  • 1-1/4" 6 M-3300
  • Multi Spindle Bar
  • 1964

Specifications

Universal Threading Pos. 6
Plain Threading Pos.5
High Speed Drilling
Independent Reaming
6 Cross Slides
Change Gears
Chip Conveyor Flat Type
Covers and Guards
Cross Slide Tool Holders
Drill Holders
Stock Reel And Stand
Upper Independent Rear SlideMaster Collets and Pushers
Height 6' 10 1/2"
Length 112
Weight 14,500 Lbs
Width 46
Bar Feed Stroke 0 - 10
Cross Slide Stroke 0-13/16
Cutoff Stroke 0 - 7/8
Idle Appr Stroke Standard 3.5"
Ind Ream Stroke 3/16 - 3 3/4"
Speed Range 255-2781 RPMMax Length Turn S tandard 8.5"
Spindle Capacity Round 1 1/4"
Spindle Capacity Sq 7/8"
Spindle Capacity Hex 1 1/16"

Notes

Two machines available from the same facility in the southeast; the other serial is 1,790,969 and is a double feed machine new in 1960 - both machines were rebilt in 1989 at a cost of $70,000 each. Price is for each machine.||Photographs are available Immediately upon request. All the tooling is included.|Each machine equipped with: (approximately)3 Knee tools, 3 low roll supports - 2 high, 4 roller turners, 1 circle form, 1 shave, 2 low flat forms - 1 high, 2 cutoff holders, 4 auxilairy slide plates, 6 f eed tubes, 18 sets of collets. Wired 480 volt, motors are dual voltage. Stem, gear box, fulcrum arms, back end, bronze gear, cross slides, all very good.|Machines were rebuilt by AMR Industries, 7725 S. 6th St., Oak Creek, WI 53154.|