Sold!
Buy one like this

I want to sell a machine like this

  • CNC Machine
  • Escomatic
  • 643D
  • Lathe - CNC
  • 6.4mm
  • 2006

Specifications

The machines of the NM64X series are available in different versions:
• as NM640 equipped with a counter collet for the turning of simple parts
• as NM641 equipped with a counter collet and a hydraulic cross slide (X2)
• as NM643F with a front machining unit with three spindles and counter
collet and as an option with a spindle for cross drilling or milling operations
• as NM644D equipped with a counter spindle (10000 min-1),
Y-axis and a back machining unit with four positions for fixed axial tools;
options: powered axial tools, C-axis or a two-spindle cross drilling or milling unit
• as NM647 equipped with a counter spindle (10000 min1), Y-axis, a three-
spindle front machining unit and a back machining unit with four positions
for fixed axial to ols; options: powered axial tools, C-axis, two-spindle cross
drilling and milling unit or one spindle for cross dril ling/milling operations
on the front machining unit
• Material diameter up to 6.50 mm from coil or bar
• Rotating toolhead with 12,000 RPM
• 4 independent cutting tools
• No cut-off burr
• Short and fast change over as well as flexibility with set-up
• Production of parts with tighter tolerances is made pos sible by using an adjustable guide bush which can be
used also as a collet during cut-off
• Higher economy due to less waste of material ends, la
bour-saving material handling and smaller floor occupa
tion because of the use of coil material
• Higher performance due to the proximity of the cutting to
ols to the work piece and a continuous material feed of
stock
• Safe 24 hours production

Notes

MINT CONDITION
2006 Esco NM 643D coil fed automatic lathe w/back working
Printed manuals
Original hand tools
Machine options:
Counter Collet with “C” axis (pick-off and Back
working)
Losma mist collector
Automatic carousel w/12 containers
Losma roll filter sump w/automatic media
advance
Additional equipment:
1) Tool presetter
1) Torque screw-driver
1) Special 90 degree milling spindle
3) Standard back working spindle (mill/drill)
1) Drive belts for back working spindles
3) Feed collets (Ø.050in., Ø2mm, Ø.125in.) plus some spares.
3) Guide bushing (same as above)
3) Counter collet w/ejectors (same as above)
6) Tool holders
1) Habegger end-knurl holder (3 wheel type)
1) Stafford knurl
holder (2 wheel straddle type)
20+) Roll filter media (60 micron)
COST over $250,000 NEW was ran as a fill in for a product he
outsourced and then just sold the product line and kept the machine.
Machine is in pristine condition with low total part count. Under 5000 run hours.
Buyer is to verify the information is correct above.
If you require any further information, please call.