Sold!
Buy one like this

I want to sell a machine like this

  • CNC Machine
  • Okuma
  • LU-35
  • Lathe - CNC
  • 1995
  • Tail Stock:
  • Dual Turrets:
 Okuma LU-35 Lathe - CNC  1995

Specifications

Maximum swing over bed 29.13"
Maximum swing over carriage 18.90"
Maximum turning diameter - upper turret 21.65"
Maximum turning diameter - lower turret 14.17"
Travel XA - upper turret 14.96" (10.83" 4.13")
Travel XB - lower turret 9.84" (7.09" 2.76")
Maximum ZA travel - upper turret 36.22"
Maximum ZB travel - lower turret 34.44"
Maximum work length - upper turret 36.22"
Spindle nose type A2-8
Spindle bore 3.54"
Spindle speeds 14-3200 RPM
Spindle drive 50 HP/40 HP
Turret type - upper/lower NC-V12/V10 Slotted
No. of tool stations - upper turret 12 (ID or OD)
No. of tool stations - lower turret 10 (OD or OD)
Rapid traverse rates - X-axis 591 IPM
Rapid traverse rates - Z-axis 787 IPM
Feed rates for X & Z-axis .000040 - 39.3700 IPM
Tailstock quill taper No. 5 MT
Quill diameter 4.72"
Quill stroke 6.69"
Approximate weight 30,000 lbs
Machine height 8'6"

Notes

Equipped With:
OSP7000L CNC Controls. NC Turret. 2 Saddle Machine.
Electric Spindle Orientation. Spindle Max. IL. Cycle Time
Reduction. OMI Message. Tape Data Input/Output.
60M Expanded Memory. Turret Position Compensation.
Tool Life Management. NC Torque Limit. Inch/Metric
Switchable. Animation. Load Monitor. MacMan. Lap 4.
tool Nose Radius Compensation 2B. User Task 2.
Expanded Auto Chamfering. Cycle Time Calculation.
Electric Spindle Orientation. Center Work. Programmable
Tailstock. Measure RS232C. Turret Air Blow. Chuck Grasp
Confirmation. Tailstock Limit. Right Door One Body. Roof
Door. Okuma Overhead Gantry System (OGL30). NC Loader
Interface Type C. Automatic Central Lubrication.
Emergency Stop Alarm A. M/C Interference. Hand In/Out
Hold. Hand A. Hand B. A Clamp. Miss Chuck. B Clamp.
Miss Chuck. Coolant. Chip Conveyor. Manuals and Drawings.